CRS03
Analogue MEMS Angular Rate Sensor
A first generation general-purpose, analogue MEMS angular rate sensor. Superceded by later generation MEMS gyros - see 'Alternative Products' below.
Product Lifecycle Status
Production Status: In Production
Note: All variants of the CRS03-xxS are now discontinued due to End of Life. For existing users of the CRS03-01S and CRS03-02S, equivalents are the CRS03-01T and CRS03-02T.
Availability: Available
Customer Applications: Existing applications only
Alternative Products
Alternative products to CRS03 are:
- Supply Voltage (Vdd)
- Analogue Dynamic Range
- SF Setting Error
- SF Error Over Temp
- Bias Setting Error
- Bias over Temperature
- Bias Instability
- Bandwidth (nominal)
- Operating Temperature
- Current Consumption
- CRS03-01T
- Under
- Supply Voltage (Vdd) : 5V
- Analogue Dynamic Range : ±100°/s
- SF Setting Error : ±3.0%
- SF Error Over Temp : ±3.0%
- Bias Setting Error : ±3°/s
- Bias over Temperature : ±3 ̊/sec
- Bias Instability : 10°/hr
- Bandwidth (nominal) : >10Hz
- Operating Temperature : -40°C to +85°C
- Current Consumption : 35mA
- CRS03-02T
- Under
- Supply Voltage (Vdd) : 5V
- Analogue Dynamic Range : ±100°/s
- SF Setting Error : ±3.0%
- SF Error Over Temp : ±3.0%
- Bias Setting Error : ±3°/s
- Bias over Temperature : ±3 ̊/sec
- Bias Instability : 10°/hr
- Bandwidth (nominal) : >10Hz
- Operating Temperature : -40°C to +85°C
- Current Consumption : 35mA
Product description
Analogue MEMS Angular Rate Sensor
A first generation general-purpose, analogue MEMS angular rate sensor. Superceded by later generation MEMS gyros - see 'Alternative Products' below.
The CRS03 products have undergone three major changes during their lifetime. The original products were NOT RoHS compliant and had no suffixes (eg CRS03-01, CRS03-04 etc). An engineering product change to make them RoHS compliant resulted in the new part numbers with an 'R' suffix (eg CRS03-01R and CRS03-04R). A later design change resulted from the change of ASIC supplier. This caused no change to their specification but resulted in new part number variants with an 'S' suffix (eg CRS03-01S, CRS03-02S). In 2016 Silicon Sensing made a change to the MEMS sensor fitted in the -01 and -02 versions of CRS03, and the new parts are identified with a ‘T’ suffix. All previous CRS03 parts are now End of Life status. CRS03-01T & -02T parts are RoHS compliant.
On power-on, it is essential that the supply voltage ramps up to 4.75V within 500ms, otherewise the gyro output can freeze. A similar problem can occur during a power supply drop-out.
Yes. For CRS03, the supply voltage must reach its nominal 5V in less than 5ms, otherwise the gyro may latch-up and will provide no output. In this condition is does not automatically reset.
PRODUCT SEARCH
